Hold Down Pins (8 per pack)

Description

These hold down pins are designed and manufactured in-house and printed in PETG for strength and flexibility. Use them to keep material flat on your honeycomb bed during cutting and engraving.

Pin Size
Pins are available in multiple diameters to match different honeycomb cell sizes. Please order the size that matches your bed. If you need a size not listed, contact us for a custom order.

If you are unsure what size to order, cut a small triangle from scrap, insert it into a honeycomb cell, mark the top of the bed, and measure across the cut piece.

Use our Pin Sizing Tool and see What size pin do I need?.

Grip Size

• 5mm grip: typically best for 1/4″ material
• 3mm grip: typically best for 1/8″ material

Profile: Regular vs Low Profile

• Regular profile: recommended for most CO2 laser setups.
• Low profile: recommended for diode setups that use short focus spacers where additional clearance is helpful.

Need Anti-Flashback protection?
Choose the Anti-Flashback Hold Down Pins if your goal is to reduce underside flashback marks while holding material off the honeycomb.

Color may vary from photos.